Baumann Electronic Controls

Transmission Help

Product Help

Performance Guide

AODE/4R70W FAQ Page

Clicking on the links to the left will open a list of frequently asked questions or advice for the category you select. Clicking on some categories will also open sub-categories designated with a -.

  1. I would like to go to 3.55's or 3.73's in my mustang, but have been told these won't work with the AODE (by local Ford dealer). What is the problem? And if there will be one, is there a way to fix it?
  2. Should I replace my pressure plate with a steel from the clutch pack to give me room to add extra clutches to my clutch drum?
  3. Which cooler line fitting on the AODE/4R70W transmission is out and which line is in?
  4. How much power can a stock AODE/4R70W transmission take?

Q. I would like to go to 3.55's or 3.73's in my mustang, but have been told these won't work with the AODE (by local Ford dealer). What is the problem? And if there will be one, is there a way to fix it?

At full throttle it will hit the rev limiter before it shifts into 2nd. You will have to lift off the accelerator to get it to shift into 2nd gear. Installation of our Baumannator TCS will solve your problem, and allow you to use any gear ratio you choose.

Back to Top

Q. Should I replace my pressure plate with a steel from the clutch pack to give me room to add extra clutches to my clutch drum?

This is not a good idea. The pressure plate is thicker than the steels so that it does not bend. The rigidity of the pressure plate helps keep the clutches and steels flat against each other to maintain maximum contact area. If the top plate is thin, and it can bend then the inside area of the fricitions can have less pressure applied to them, and decrease holding force.

Back to Top

Q. Which cooler line fitting on the AODE/4R70W transmission is out and which line is in?

On the AODE/4R70W transmission, fluid leaves the transmission through the lower case fitting, and returns from the cooler through the upper case fitting. Please note, this is NOT true for the AOD.

Back to Top

Q. How much power can a stock AODE/4R70W transmission take?

The AODE/4R70W in stock form can typically handle about 25 to 50 horsepower above stock power levels. Before planning many engine mods to an AODE/4R70W equipped vehicle, you should install our AODE Valve Body Kit. Installation of the Valve Body kit will allow 1997 and earlier AODE/4R70W transmissions to perform reliably in a 350 to 375 horspower application. 1998 and later 4R70Ws can handle up to 500 horsepower with just the addition of the Valve Body kit. If your power goals are higher, you should consider having the transmission rebuilt with heavy duty components from our AODE/4R70W Performance Products Catalog

Back to Top

Baumann Electronic Controls, LLC
702 South Mechanic Street
Pendleton, SC 29670
Phone: 864-646-8920
Fax: 864-646-8920

All information, text and graphics contained within this site are the exclusive property of Baumann Electronic Controls, LLC and may not be used or reproduced in any form without the express written consent of Baumann Electronic Controls, LLC.


Last updated on June 28, 2004